Table of Contents
Advertisement
STEP 6:
ATTACH
THE OVEN TO THE WALL
WARNING
You will need two people to lift this
microwave.
Failure to use more than one
person could result in personal
injury.
1. Carefully lift microwave oven and hang it on support tabs
(See Figure 28) at the bottom of the mounting plate.
Reaching through upper cabinet, thread power supply cord
through the power supply cord hole in the bottom of the
upper cabinet. See Figure 32.
2. Rotate microwave upward so that top of oven is against
bottom of upper cabinet or cabinet frame.
Figure 32
3. Drop the lock pin and washer assembly into hole "N" (left
side hole) and push pin down as far as it will go.
See Figure 33.
4. Place washers over two, 1/4"x3" bolts. Then insert a bolt
down through each hole in the upper cabinet bottom.
Tighten the bolts until the gap between the upper cabinet
and microwave oven is closed. See Figure 34.
fs
Figure
33
5. Remove lock pin and washer.
If walt-vented or room-vented installation is used, go to
No. 8 on the next page.
Figure 34
m15m
Advertisement
Table of Contents
