GE PSE25KGHBHBB Owner's Manual page 20

Replacing the light buibs.¢onsom rnod ,'s
Before replacing a burned-out light bulb, the refrigerator should be unplugged in order to avoid contact with a
live wire filament, (A burned-out light bulb may break when being replaced,)
Turning the control to the OFF position does not remove power to the light circuit,
Your fight shield will look like
one of the following; 0
s
oR 0
Refrigerator Compartment--Upper Light
Unplug the refrigerator,
The bulbs are located at the top of the
compartment, inside the light shield, On some
models, a screw at the front of the light shield
will have to be removed, On other models, the
screw is located in the pocket located at the
back of the light shield,
To remove the light shield, on some models,
press in on the tabs on the sides of the shield
and slide forward and out, On other models,
just slide the shield forward and out,
O After replacing the bulb with an appliance
bulb of the same or lower wattage, replace
the light shield and screws (on some models),
When replacing the light shield, make sure
that the tabs at the back of the shield fit into
the slots at the back of the light shield
housing,
Plug the refrigerator back in,
Refrigerator Compartment--Lower Light
This fight is located above the top drawer,
Unplug the refrigerator,
0 Remove the convertible meat drawer
control knob by pulling straight out,
_t After replacing the bulb with an appliance
bulb of the same or lower wattage, replace
the shield and the knob,
Plug the refrigerator back in,
0 Lift the light shield up and pull it out,
........................ -ii
Freezer Compartment
Unplug the refrigerator,
Remove the shelf just above the light shield,
(The shelf will be easier to remove if it is
emptied first,) On some models, a screw at
the top of the light shield will need to be
removed,
To remove the light shield, press in on the
sides, and lift up and out,
O
Replace the bulb with an appliance bulb
of the same or lower wattage, and
reinstall the light shield, When
reinstalling the light shield, make sure
the top tabs snap securely into place,
Replace the screw (on some models),
Reinstall the shelf and plug the
refrigerator back in,
2O