Range Hood Care; Cleaning - KitchenAid KVIB606DSS0 Installation Instructions And Use & Care Manual

36" and 42" (91.4 cm and 106.7 cm) island canopy range hood
Table of Contents

Advertisement

Available languages

Available languages

To Deactivate Auto Sense:
If the Auto button is lit, press AUTO once to deactivate Auto
Sense. The Auto button light will turn Off.
If Auto Sense is in Sleep Mode, press AUTO once to
deactivate Sleep Mode and turn the Auto button light On.
Press AUTO again to deactivate Auto Sense and turn Off the
Auto button light.
Auto Sense will automatically
turn off after 2 hours of no
activation of the Auto Sense system. To reset Auto Sense
press AUTO.
Manual Vent Functions
Fan Speeds
Low
Med
Hi
Boost
Press LOW to turn the fan on at Low speed.
Press MED to turn the fan on at Medium speed.
Press HI to turn the fan on at High speed.
Press BOOST to turn the fan on at the highest
speed. Boost will automatically turn Off after
10 minutes and the fan will switch to High speed.
Timer
The range hood can be set to automatically turn off after
15 minutes.
1. Press and hold the desired fan speed button for 2 seconds.
The fan will run on the chosen speed for 15 minutes and the
fan speed button light will flash continuously.
After 15 minutes, the fan will turn Off automatically.
2. Press the desired fan speed button again while the fan timer
is running to cancel the fan timer.
NOTE: Changing the fan speed or turning Auto Sense On will
also cancel the 15-minute timer.
Light
The range hood has both task and ambient lighting.
To operate the lights:
1. Touch LIGHT once to turn the LED task lights On.
2. Touch LIGHT again to turn LED task lights Off. The ambient
lights will turn On.
3. Touch LIGHT a third time to turn the ambient lights Off.
NOTE: To turn both the task and ambient lights on at the same
time, touch and hold LIGHT for 2 seconds. Touch LIGHT again to
turn the task and ambient lights Off.
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning
Method:
Liquid detergent soap and water, or all-purpose
cleanser
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
1=
Metal Grease Filter
Open the stainless steel panel. Grasp panel at the front
corners and pull down to disengage the 2 catch pins from the
spring catches. The panel is attached at the rear and will
rotate down.
D
A
\
\
C
A. Metal filters
C. Catch pins (2)
B. Stainlesssteel panel
D. Spring catches (2)
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kvib602dss0

Table of Contents