Chevrolet 2007 Avalanche Owner's Manual page 504

Your vehicle's TPMS can alert you about a low
tire pressure condition but it does not replace
normal tire maintenance. See Tire Inspection and
Rotation on page 506 and Tires on page 492.
Notice: Do not use a tire sealant if your
vehicle has Tire Pressure Monitors. The liquid
sealant can damage the tire pressure monitor
sensors.
Resetting the TPMS Identification Codes
Each TPMS sensor has a unique identification
code. Any time you rotate your vehicle's tires
or replace one or more of the TPMS sensors,
the identification codes will need to be matched
to the new tire/wheel position. The sensors
are matched to the tire/wheel positions in the
following order: driver's side front tire, passengers
side front tire, passengers side rear tire, and
driver's side rear tire using a TPMS diagnostic tool.
See your GM dealer for service.
504
The TPMS sensors may also be matched to each
tire/wheel position by increasing or decreasing
the tire's air pressure. If increasing the tire's
air pressure, do not exceed the maximum inflation
pressure indicated on the tire's sidewall.
You will have two minutes to match the first
tire/wheel position, and five minutes overall to
match all four tire/wheel positions. If it takes longer
than two minutes, to match the first tire and
wheel, or more than five minutes to match all
four tire and wheel positions the matching process
stops and you will need to start over.
The TPMS sensor matching process is outlined
below:
1. Set the parking brake.
2. Turn the ignition switch to RUN with the
engine off.
3. Using the DIC, press the vehicle information
button until the RELEARN TIRE POSITIONS
message displays. If your vehicle does not
have the DIC buttons, press the trip odometer
reset stem located on the instrument panel
cluster until the RELEARN TIRE POSITIONS
message displays.
I n f o r ma t i o n P r o v i d e d b y :