Sharp LC-46D65E/RU Service Manual page 8

LC-46D65E/RU
Attaching the stand unit
Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent
it from being damaged.
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1
Confirm that there are 8 screws (4 short screws
and 4 long screws) with the stand unit.
2
Attach the supporting post for the stand unit
onto the base using the 4 long screws with the
hex key (supplied) as shown.
Supporting
Hex key
Long
screw
post
3
Inserting the stand.
1
Insert the stand into the openings on the
bottom of the TV (Hold the stand so it will
not drop from the edge of the base area).
2
Insert and tighten the 4 short screws into
the 4 holes on the rear of the TV.
Short
screw
Soft
cushion
NOTE
To detach the stand unit, perform the steps in reverse
order.
1 – 4
Hex key