Coolant - Yamaha XMax YP400RXMAx YP400RA Owner's Manual

1
2
1. Final transmission oil filler cap
2. O-ring
3. Final transmission oil drain bolt
4. Gasket
5. Remove the final transmission oil
drain bolt and its gasket to drain
the oil from the final transmission
case.
6. Install the final transmission oil
drain bolt and its new gasket, and
then tighten the bolt to the speci-
fied torque.
Tightening torque:
Final transmission oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
7. Refill with the specified amount of
the recommended final transmis-
sion oil. WARNING! Make sure
PERIODIC MAINTENANCE AND ADJUSTMENT
that no foreign material enters
the final transmission case.
Make sure that no oil gets on
the tire or wheel.
4
Recommended final transmission
oil:
3
See page 8-1.
Oil quantity:
0.25 L (0.26 US qt, 0.22 Imp.qt)
8. Install the final transmission oil fill-
er cap and its new O-ring, and
then tighten the oil filler cap.
9. Check the final transmission case
for oil leakage. If oil is leaking,
check for the cause.
6-16

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
[EWA11312]
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on a level surfa-
ce and hold it in an upright posi-
tion.
2. Open the front storage compart-
ment A. (See page 3-16.)
TIP
 The
checked on a cold engine since
the level varies with engine tem-
perature.
 Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
3. Check the coolant level through
the check window.
EAU20071
EAUM3043
coolant level must be
6