Final Transmission Oil - Yamaha XMax YP400RXMAx YP400RA Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
 Be sure no foreign material en-
ters the crankcase.
10. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
11. Reset the oil change indicator ac-
cording to the following proce-
6
dure.
To reset the oil change indicator
1. Turn the key to "ON".
2. Hold the "OIL CHANGE" button
pushed for 15 to 20 seconds.
ZAUM1051
1. "OIL CHANGE" button
3. Release the "OIL CHANGE" but-
ton, and the oil change indicator
will go off.
TIP
If the engine oil is changed before the
oil change indicator comes on (i.e. be-
fore the periodic oil change interval has
been reached), the indicator must be
reset after the oil change for the next
periodic oil change to be indicated at
the correct time. To reset the oil chan-
ge indicator before the periodic oil
change interval has been reached, fol-
low the above procedure, but note that
the indicator will come on for 1.4 sec-
onds after releasing the "OIL CHAN-
GE" button, otherwise repeat the
procedure.
1

Final transmission oil

The final transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair the
scooter. In addition, the final transmis-
sion oil must be changed as follows at
the intervals specified in the periodic
maintenance and lubrication chart.
1. Start the engine, warm up the final
2. Place the scooter on the center-
3. Place an oil pan under the final
4. Remove the final transmission oil
6-15
transmission oil by riding the
scooter for several minutes, and
then stop the engine.
stand.
transmission case to collect the
used oil.
filler cap and its O-ring from the fi-
nal transmission case.
EAU20067