High Speed; Wireless Statistics - TP-Link RE210 User Manual

Beacon Interval - Specifies a value between 40-1000 milliseconds. The beacons are the

packets sent by the device to synchronize a wireless network. Beacon Interval value
determines the time interval of the beacons. The default value is 100.
RTS Threshold - Specifies the RTS (Request to Send) Threshold. If the packet is larger

than the specified RTS Threshold size, the device will send RTS frames to a particular
receiving station and negotiate the sending of a data frame. The default value is 2346.
Fragmentation Threshold - This value is the maximum size determining whether packets

will be fragmented. Setting the Fragmentation Threshold too low may result in poor network
performance since excessive packets. 2346 is the default setting and is recommended.
DTIM Interval - Determines the interval of the Delivery Traffic Indication Message (DTIM).

You can specify the value between 1-255 Beacon Intervals. The default value is 1, which
indicates the DTIM Interval is the same as Beacon Interval.
Enable WMM - WMM function can guarantee the packets with high- priority messages being

transmitted preferentially. It is strongly recommended enabled.
Enable Short GI - This function is recommended for it will increase the data capacity by

reducing the guard interval time.
Enable AP Isolation - Isolates all connected wireless stations so that wireless stations

cannot access each other through WLAN.

4.4.5 High Speed

Selecting Wireless > High Speed allows you to configure the wireless mode for your device
(show in Figure 4-15).
Concurrent-Dual Band Range Extender – Extends both 2.4GHz and 5GHz bands for the

router.
High Speed Mode – Boost the WiFi speed but only one band could be extended.

High Speed Mode 1 – Connect to the router on 2.4GHz only and connect to the WiFi

clients on 5GHz only;
High Speed Mode 2 – Connect to the router on 5GHz only and Extend to the WiFi clients

on 2.4GHz only.

4.4.6 Wireless Statistics

Selecting Wireless > Wireless Statistics will allow you to see the wireless transmission
information in the following screen shown in Figure 4-16.
RE210 AC750 WiFi Range Extender User Guide
Figure 4-15 High Speed
21