Page 1
Cordless Recipro Saw INSTRUCTION MANUAL SPECIFICATIONS Model 4390D Max. cutting capacities Length stroke Soft wood Hard wood 15” 24 mm W 1 6 ” ) (15/16”) (1/2”l Voltage Charging time Pipe Outer dia. Thickness mm x 2 (1-518’’ 5/64”) Input A.C.
SAFETY INSTRUCTIONS WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFE- TY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PER- SONAL INJURY, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS. KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries. CONSIDER WORK AREA ENVIRONMENT.
Page 3
1. Remove the battery from the tool. 2. a). Take the battery to your nearest Makita Factory Service Center Take the battery to your nearest Makita Authorized Service Center or Distributor that has been designated as a Makita battery recycling location.
Page 4
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS Length of Cord (Feet) AWG Size of Cord Do not operate charger with damaged cord or plug diately. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged Do not disassemble charger or battery cartridge;...
ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE Do not charge Battery Cartridge when temperature is or ABOVE 4OoC (104OF). Do not attempt to use a step-up transformer, an engine generator or DC power receptacle. Do not allow anything t o cover or clog the charger vents. 4.
Page 6
Installing or removing battery cartridge Always switch off the tool before insertion or removal of * T o remove the battery cartridge, pull out plate on the tool and grasp both sides of the cartridge while withdrawing it from the barrel. .To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip...
Page 7
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger. Installing or removing saw blade CAUTION: Always be sure that the tool installing or removing the blade. Loosen the blade securing bolt fully with the wrench.
Page 8
After use, return the hex wrench to the storage position. Switch action To prevent the trigger from being acciden- tally pulled, lock-off lever is provided safety feature. as a To start the tool, slide the lock-off lever in the direction of the arrow and pull the trigger.
CAUTION Always be sure that the tool attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. oil) will fresh battery.
Page 10
OPTIONAL ACCESSORIES The accessories listed in this manual are available at an extra cost from your Makita distributor or Makita factory service center. Service centers are listed on the warranty card packed with your tool. C A U T I O N : These accessories or attachments are recommended for use with your Makita t o o l specified in this manual.
Page 11
fib-19-’91 CORDLESS RECIPRO SAW Model 43900...
IN NO EVENT SHALL MAKITA BE LIABLE FOR ANY INDIRECT INCIDENTAL OR CON- SEQUENTIAL DAMAGES FROM THE SALE APPLIES BOTH DURING AND AFTER THE TERM MAKITA DISCLAIMS LIABILITY FOR ANY IMPLIED WARRANTIES INCLUDING IMPLIED WARRANTIES OF “MERCHANTABILITY”...