Connect The Water Supply Line; Connect The Electrical Components; Connect The 120 Volts Ac Supply - Norcold N62 Series Installation Manual

Connect the water supply line:

Install a 1/4 in. OD water supply line [43] from the water shut off valve of the vehicle to the
solenoid water valve [44] at the rear of the refrigerator (See Art01014):
A brass compression nut [45], a brass sleeve, a plastic sleeve [46] , and a
NOTICE
brass insert [47] are supplied and attached to the rear of the refrigerator (See
Art01755).
- Put the compression nut and then the sleeve onto the water supply line [43].
- For copper tubing, use the brass sleeve.
- For plastic tubing, use the plastic sleeve [46].
- For plastic tubing with .040 in. wall thickness, also use the brass insert [47].
- Flush the water supply line until the water is clear.
- Put the tubing into the water valve until it is against the stop.
- Tighten the compression nut by hand (hard finger tight).
- Using two wrenches, tighten the compression nut 1 ½ to 2 turns.
- Open the water shut off valve of the vehicle.
- Examine the connections for leaks.

Connect the Electrical Components

AC Operation
DC Operation
This refrigerator operates on these electrical sources. Operation out of these limits may damage the refrigerator's electrical circuit
parts and will void the warranty.
The rear of the refrigerator cooling system has hot surfaces and sharp surfaces that can damage electrical
!
WARNING
wiring. Make sure that there is a good clearance between all electrical wiring and the cooling system of the
refrigerator. Position any electrical wiring within the refrigerator enclosure opposite the burner side of the
refrigerator. Do not put any electrical wiring through the roof exhaust vent. Failure to correctly position
electrical wiring can result in electrical shock or fire.

Connect the 120 volts AC supply:

Connect the AC power cord(s) only to a grounded three-prong receptacle. Do not remove the round
!
WARNING
ground prong from any of the AC power cords. Do not use a two prong adapter or an extension cord with
any of the AC power cords. Operation of the refrigerator without correct ground can cause dangerous
electrical shock or death if you are touching the metal parts of the refrigerator.
Put the AC power cord(s) into a grounded three-prong receptacle:
- Make sure the receptacle is positioned within easy reach of the lower intake vent.
- Make sure the power cord(s) does not touch the burner cover, the flue pipe, or any hot component that could damage the insulation
of the power cord.
Installation Manual 16
120 volts AC voltage
12 volts DC control voltage
12 volts DC control voltage
(132 volts max. - 108 volts min.)
(15.4 volts max. - 10.5 volts min.)
(15.4 volts max. - 10.5 volts min.)
44
48
43
45
Art01014