Gps Data - Nokia N85 User Manual

Hide thumbs Also See for N85:
Table of Contents

Advertisement

Add to category
category in Landmarks. Select each category to
which you want to add the landmark.
Send
— Send one or several landmarks to a
compatible device. Your received landmarks are
placed in the Inbox folder in Messaging.
You can sort your landmarks into preset categories,
and create new categories. To edit and create new
landmark categories, open the categories tab, and
select
Options
>

GPS data

Press
, and select
data.
The coordinates in the GPS are expressed in degrees
and decimal degrees format using the international
WGS-84 coordinate system.
To use GPS data, the GPS receiver of your device
must initially receive position information from at
least four satellites to calculate the coordinates of
your location. When the initial calculation has been
made, it may be possible to continue calculating the
coordinates of your location with three satellites.
However, the accuracy is generally better when
more satellites are found.
52
— Add a landmark to a
Edit
categories.
Tools
Connectivity
>
Route guidance
Press
and select
Navigation.
Start the route guidance outdoors. If started
indoors, the GPS receiver may not receive the
necessary information from the satellites.
Route guidance uses a rotating compass on the
device display. A red ball shows the direction to the
destination, and the approximate distance to it is
shown inside the compass ring.
Route guidance is designed to show the straightest
route and the shortest distance to the destination,
measured in a straight line. Any obstacles on the
GPS
>
route, such as buildings and natural obstacles, are
ignored. Differences in altitude are not taken into
account when calculating the distance. Route
guidance is active only when you move.
To set your trip destination, select
destination
and a landmark as the destination, or
enter the latitude and longitude coordinates.
To clear the destination set for your trip, select
navigation.
Retrieve position information
Press
, and select
data
> Position.
Tools
Connectivity
>
>
Options
>
Tools
Connectivity
>
Set
Stop
GPS
>

Advertisement

Table of Contents
loading

This manual is also suitable for:

N seriesN85-1

Table of Contents