Connect Wireless Devices To Your Router; Connect Wireless Devices Using Wps - TRENDnet TEW-721BRM User Manual

TRENDnet User's Guide
o RADIUS Server IP: Enter the IP address of the RADIUS server. (e.g. 192.168.10.250)
o RADIUS Port: Enter the port your RADIUS server is configured to use for RADIUS
authentication.
Note: It is recommended to use port 1812.
o RADIUS Shared Key: Enter the shared key (or shared secret) used to authorize your
router with your RADIUS server.

Connect wireless devices to your router

A variety of wireless network devices can connect to your wireless network such as:
 Gaming Consoles
 Internet enabled TVs
 Network media players
 Smart Phones
 Wireless Laptop computers
 Wireless IP cameras
Each device may have its own software utility for searching and connecting to available
wireless networks, therefore, you must refer to the User's Manual/Guide of your
wireless client device to determine how to search and connect to this router's wireless
network.
See the "Appendix" on page 59 for general information on connecting to a wireless
network.
© Copyright 2014 TRENDnet. All Rights Reserved.

Connect wireless devices using WPS

Setup > Wireless Settings > WPS Setup
WPS (Wi-Fi Protected Setup) is a feature that makes it easy to connect devices to your
wireless network. If your wireless devices support WPS, you can use this feature to
easily add wireless devices to your network.
Note: You will not be able to use WPS if you set the SSID Broadcast setting to Disabled.
There are two methods the WPS feature can easily connect your wireless devices to
your network.
 Push Button Configuration (PBC) method
o RECOMMENDED Hardware Push Button method–with an external button located
physically on your router and on your client device
o WPS Software/Virtual Push Button - located in router management page
 PIN (Personal Identification Number) Method - located in router management page
Note: Refer to your wireless device documentation for details on the operation of
WPS.
Recommended Hardware Push Button (PBC) Method
Note: it is recommended that a wireless key (passphrase or password) is created
before connecting clients using the PBC method. If no wireless key is defined when
connecting via PBC, the router will automatically create an encryption key that is 64
characters long. This 64 character key will then have to be used if one has to
connect computers to the router using the traditional connection method.
To add a wireless device to your network, simply push the WPS button on the wireless
device you are connecting(consult client device User's Guide for length of time), then
push and hold the WPS button located on your router for 3 seconds and release it. The
WLAN LED on your modem router will flash rapidly indicating that the WPS setup
process has been activated. (See "Product Hardware Features" on
For connecting additional WPS supported devices, repeat this process for each
additional device.
TEW-721BRM
page 2)
13