Table of Contents
Advertisement
544 STARTING AND OPERATING
vehicle's recommended cold tire placard pressure value
(located on the placard label on the driver's-side B-Pillar).
NOTE: When filling warm tires, the tire pressure may
need to be increased up to an additional 4 psi (30 kPa)
above the recommended cold placard pressure in order
to turn the Tire Pressure Monitoring Telltale Light off.
The system will automatically update and the "Tire
Pressure Monitoring Telltale Light" will extinguish once
the updated tire pressures have been received.
NOTE: The vehicle may need to be driven for up to 10
minutes above 15 mph (24 km/h) to receive this infor-
mation.
SERVICE TPM SYSTEM
The "Tire Pressure Monitoring Telltale Light" will flash
on and off for 75 seconds, and remain on solid when a
system fault is detected. The system fault will also sound
a chime. If the ignition switch is cycled, this sequence will
repeat, providing the system fault still exists. The "Tire
Pressure Monitoring Telltale Light" will turn off when
the fault condition no longer exists. A system fault can
occur with any of the following scenarios:
• Jamming due to electronic devices or driving next to
facilities emitting the same radio frequencies as the
TPMS sensors.
• Installing some form of aftermarket window tinting
that affects radio wave signals.
• Accumulation of excessive snow and/or ice around
the wheels or wheel housings.
• Using tire chains on the vehicle.
• Using wheels/tires not equipped with TPMS sensors.
I n f o r ma t i o n P r o v i d e d b y :
Advertisement
Table of Contents
