WARNING U-Line Corporation direct. Consult the installation guide before any installation begins. U-Line contact SHOCK HAZARD - Electrical Grounding Required. information appears on the rear cover of this guide. • Never attempt to repair or perform maintenance on •...
Product Registration • Drill & Drill Bits (If installing 1/4" Panel Insert) You have received a carton containing your U-Line Combo Drawer Model Ice Maker/Refrigerator or U-Line Refrigerator with a • 1/4" thick door panel material package inside containing a Use and Care Guide, a Product •...
C2275DWR Series 3 Prepare Site Your U-Line product has been designed for either free-standing or built-in installation. When built-in, your unit does not require additional air space for top, sides, or rear. However, the front grille must NOT be obstructed and clearance is required for an electrical connection in the rear.
The drawer unit can be installed with an appliance or fixture located in front of it, as long as there is adequate clearance for the drawer to be opened and removed when servicing. U-Line recommends you consider additional clearance in front of the open drawer for convenience. 24" Min.
This is CAUTION caused by the front slide mountings not being level with Use care when handling the drawer. Drawer edges, drawer the rear slide mountings. rail and the unit’s slide may be sharp. Side View of Unit u-line.com...
1. Set the drawer’s rails onto the slides. Not Aligned Top-to-Bottom 2. Re-install the rails’ mounting screws. Not Aligned Left-to-Right 3. Plug in the drawer’s connection wiring (top drawer only). Front View of Unit Top View of Unit u-line.com...
Full Handle 7. Install two small screws removed in Step 2. 8. Starting at the corners and working inward, push drawer gasket into place on drawer. u-line.com...
1. Starting at the corners and working toward the center, push the drawer gasket back into place. Repeat for both drawers. 9-5/16" 7-5/16" Note: Be sure to drill completely through frame. Top Down Slice View Steel Plate Bottom Of Panel Drawer Reveal Panel Toe Kick u-line.com...
Hook and Loop Fastener Mount 8 Wood Grille Overlay You may also mount your overlay to your grille using hook and loop type fasteners. U-Line recommends using 3M® Dual lock® Grille Overlay fasteners. To mount your overlay using a hook and loop fastener, follow the instructions below.
However, make certain that the tubing is not pinched or damaged during installation. NOTICE U-Line requires the use of copper tubing, or U-Line water line hook up kit (U-MPWATERHOOKUP) for installation. Do not use any plastic water supply line. The line is under pressure at all times.
Make sure the water line’s discard. brass fitting is screwed tight to its valve and threaded correctly. Horizontal Mounting Countertop or Wall Header (Left Side Shown) Vertical Mounting (Left Side Shown) Cabinet or Wall Stud u-line.com...
First Time Start-Up All U-line units are shipped from the factory with controls that are preset. No initial adjustments are required. Once installation and leveling is complete, the unit is ready for initial start-up and operation. Open the top drawer press and hold the POWER icon on the display panel for approximately ten seconds until the °F symbol flashes and release.
Page 17
E-mail: onlineparts@u-line.com BUILDING ON THREE GENERATIONS OF INNOVATION For over five decades and through three generations, U-Line continues to be the leader in innovation, quality and performance in the premium built-in undercounter ice making, refrigeration and wine preservation market. U-Line has captivated those with an appreciation for the finer things with exceptional functionality, style, inspired innovation and attention to even the smallest details.