What To Do If - Bosch WAE-24463 BC Instruction Manual

What to do if ...

Water is leaking out. – Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply. – (Start/Reload)
Detergent not dispensed. not selected?
– Tap not turned on?
– Filter blocked? Clean the filter -> page
– Supply hose kinked or trapped?
Washing machine door – Safety function active. Programme stopped? -> page
cannot be opened.
– (Rinse Hold =
– Can be opened by emergency release only?
Programme does not start. –
(Start/Reload) or
– Washing machine door closed?
– Childproof lock active? Deactivate -> page
Detergent solution is not
– (Rinse Hold =
drained.
– Clean the detergent solution pump -> page
– Clean the waste pipe and/or drainage hose.
Water not visible in the – Not a fault - water below the visible area.
drum.
Unsatisfactory spin result. – Not a fault - the unbalanced-load detection system has cancelled the
Laundry wet/too damp. spin cycle because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the drum
(Easy-iron)
–
– Selected speed too low? –> page 5.
The programme length – Not a fault - the number of spin cycles may be changed due to the
jumps during the final spin.. varying distribution of the laundry, which may cause the time in the
display panel to be corrected.
Spin cycle performed – Not a fault - unbalanced load detection system adjusts the imbalance.
several times.
Residual water in the – Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary -> page
products.
Odour formation in the – Run programme
washing machine.
standard detergent.
Status display flashing. – Too much detergent used?
Appliance has detected a If foam is escaping from the detergent drawer:
detergent overload. Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
compartment
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation, – Are the appliance feet fixed?
vibrations and "wandering"
Secure the appliance feet
during the spin cycle.
– Transportation safety devices removed?
Remove the transportation safety devices –> Installation instructions.
Display panel/indicator – Power cut?
lamps do not function – Fuses triggered? Reset/change the fuse.
during operation. – If the fault occurs repeatedly, call customer services.
Programme sequence – Not a fault - unbalanced load detection system adjusts imbalance by
longer than usual. repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse
cycle.
Detergent residues on the – Occasionally, phosphate-free detergents contain water-insoluble
laundry. residues.
– Use the
washing.
If you cannot correct a fault yourself or a repair is required:
– Turn the programme selector to
– Turn off the water supply and call customer services –> Installation instructions.
Downloaded From WashingMachine-Manual.com Manuals
10
.
) selected? ->
-> page 9.
(Finished in) time selected?
5 .
-> page 3, 4.
) selected?
10
.
selected? –> page 5.
9
.
(Cottons) 90 °C without laundry. Use
II (not with outdoor or down fabrics).
–> Installation instructions
(rinse) cycle or brush out the laundry after
. (Off) and remove the mains plug from the socket.
4 .
page 3, 4.
.
Observe the safety instructions on page 8.
Read these instructions and the separate installation instructions before
operating the washing machine.
11
Washing machine
Instruction manual en