Advertisement
Switch action
Move the reversing switch lever to the
"FWD" position for colckwise rotation or
the "REV" position for counterclockwise.
Tool speed is increased by increasing pres-
sure on the tigger. To start the tool, simply
pull the trigger. Release the trigger to stop.
When the reversing switch lever i s in the
neutral position, the tool will not start
even if you pull the trigger.
CAUTION :
a
Always check the direction of rotation before drilling.
*Use the reversing switch lever only when the tool comes to
a
complete stop. Changing
a
When not operating the tool, keep the reversing switch lever in the neutral position.
the direction of rotation before the tool stops may ruin the tool.
7
Advertisement
