Mounting The Guide Bar And Saw Chain - Makita DCS 6400 Owner's And Safety Manual

PUTTING INTO OPERATION
CAUTION:
Before doing any work on the guide bar or chain, always
switch off the engine and pull the plug cap off the spark
plug (see "Replacing the spark plug"). Always wear protec-
tive gloves1
CAUTION:
Start the chain saw only after having assembled it com-
pletely and inspected.
Mounting the guide bar and saw chain
Use the universal wrench delivered with the chain saw for the
following work.
Put the chain saw on a stable surface and carry out the
following steps for mounting the guide bar and saw chain:
Release the chain brake by pulling the hand guard (1) in
direction of arrow.
Unscrew retaining nuts (2).
Pull off the sprocket guard (3).
Position the guide bar (4) and push against the sprocket (5) as
shown by the arrow.
i
Lift the chain (6) over the sprocket (5). Using your right hand,
guide the chain into the top guide groove on the guide bar
( 7 ) .
Note that the cutting edges along the
top of
!he chain must point
in the direction of the arrow!
18