Sony XBA-H1 Operating Instructions

Stereo Headphones
Operating Instructions
Mode d'emploi
Manual de instrucciones
XBA-H1
Specifications
English Stereo headphones
Type: Closed, hybrid / Driver unit: Hybrid 2-way
Features (9 mm dynamic + Balanced Armature) / Power
handling capacity: 100 mW (IEC*) / Impedance:
ˎ Hybrid 2-way Driver unit ˎ
40 Ω (at 1 kHz) / Sensitivity: 105 dB/mW /
Sony's unique Hybrid 2-way driver unit (9 mm
Frequency response: 5 Hz – 25,000 Hz / Cord:
dynamic driver unit and Balanced Armature driver
Approx. 1.2 m (47
unit) delivers crystal clear and profound vocal
Gold-plated L-shaped stereo mini plug / Mass:
sound with extended bass.
Approx. 7 g (0.25 oz) without cord
ˎ Beat Response Control ˎ
Beat Response Control delivers tight and deep
Supplied accessories
bass response, perfect for today's music.
Hybrid silicone rubber earbuds: SS (red) (2), S
ˎ Suppression Housing ˎ
(orange) (2), M (green) (attached to the unit at the
Each driver is place into one suppression housing.
factory) (2), L (light blue) (2) / Foamed silicone
The housing material suppresses unwanted
earbuds: S (orange) (2), M (green) (2), L (light blue) (2)
vibrations to reproduce crystal clear sound.
/ Cord adjuster (winds cord up to 50 cm) (1) / Clip (1)
ˎ Foamed Silicone Earbuds ˎ
/ Carrying case (1)
Stable fitting and high isolation for ambient noise
* IEC = International Electrotechnical Commission
with soft foamed silicone inside of earbuds.
Design and specifications are subject to change
without notice.
Optional replacement earbuds can be ordered
from your nearest authorized Sony retailer or
www.sony.com.
How to use / Utilisation / Utilización
4-472-051-41(1)
About foamed silicone earbuds
Supplied foamed silicone earbuds provide a snug fit
for effective attenuation of ambient noise.
Notes
ˎ Prolonged use of snugly fitting earbuds may strain ˎ
your ears. If you experience discomfort, discontinue
/ in), OFC Litz cord (Y-type) / Plug: use.
1
4
ˎ The foamed silicone portion of the earbuds is very
ˎ
fragile. If it is damaged, the earbuds may not sit
correctly in your ears, and noise isolation may be
affected.
ˎ The foamed silicone may deteriorate or harden over ˎ
time, and noise isolation may be affected.
ˎ Do not subject the foamed silicone portion to ˎ
pressure over long periods, as it may cause
deformation.
Earbuds / Oreillettes / Almohadillas
Hybrid silicone rubber earbuds
Oreillettes en caoutchouc de silicone hybride
Almohadillas de caucho de silicona híbridas
SS S M
Foamed silicone earbuds
Oreillettes en mousse silicone
Almohadillas de espuma de silicona
S M L
Removing the headphones
After use, remove the headphones slowly.
Note
Headphones are designed to fit closely in your ears. If
the headphones are pressed hard while in use or
taken off too quickly, they may cause injury.
ˎ Do not leave the stereo headphones in a location ˎ
Wearing headphones may produce a diaphragm click
subject to direct sunlight, heat or moisture.
sound. This is not a malfunction.
Note on static electricity
Static electricity accumulated in the body may cause
Precautions
mild tingling in your ears.
To minimize the effect, wear clothes made from
High volume may affect your hearing.
natural materials.
For traffic safety, do not use while
driving or cycling.
Install the earbuds firmly. If an earbud
accidentally detaches and is left in
your ear, it may cause injury.
L
Foamed
silicone (Red)
Mousse
silicone
(Rouge)
Espuma de
silicona (Rojo)
Keep earbuds clean. To clean the
earbuds, wash them with a mild
detergent solution.
©2013 Sony Corporation
Printed in Thailand