AEG ÖKO-LAVAMAT 86760 User Manual page 33

Problem
Washing machine vi-
brates during operation
or is unstable.
Excessive foaming dur-
ing the main wash.
Water leaks out of the
washing machine.
Possible cause
Transport packaging has not
been removed.
The machine is not level.
There is very little washing in
the drum (e.g. only a dressing
gown).
Water could not be fully
pumped out before spinning
because the drain hose is
kinked or water pump is
blocked.
Probably too much detergent
has been used.
The screw Connection on the
inlet hose is leaking.
Drainage hose is leaking.
The drain pump cover is not
correctly close.
Washing is caught in the
door.
The emergency emptying
hose is not correctly closed
or is leaking.
Operating Instructions
Remedy
Remove transport packaging
according to setting up and
connection instructions.
Adjust the feet according to
installation and connection
instructions.
This does not affect the op-
eration of the machine.
Check the drain hose and re-
move any kink if necessary,
or clean the drain pump and,
if necessary, remove foreign
bodies from the pump hous-
ing.
If may be necessary to re-
duce the amount of deter-
gent used. Follow the
detergent manufacturer's
recommendations.
Tighten the inlet hose screw
connection.
Check the drain hose and re-
place it if necessary.
Close cover correctly.
Stop the programme, remove
the washing caught in the
door. Restart the programme.
Close the emergency empty-
ing hose (see section „Carry
out emergency emptying").
Call your local Service Force
Centre if the emergency
emptying hose is leaking.
33