Philips/Magnavox CCX133AT99 Owner's Manual page 33

4
Use the Number buttons (1 - 8) to select a position in
which to store the timer recording. Flashing numbers indi-
cate an open position (one in which a timer recording has not yet
been stored).
NOTE: If you select a number that has already been used to store a
timer recording, PREVIOUSLY SET PROGRAM will appear on-screen for
a few seconds. Then information about the program in that position
will appear on-screen. If this happens, press the STATUS/EXIT button.
Then use the Number buttons to select another position.
5
Enter the channel of the TV program you want to record (you
must enter a 0 before all single digit channels).
If you are recording from line input, press 0, 0. A/V IN will
appear on-screen.
If you are recording using a Cable Box,enter the Cable Box out-
put channel (03 or 04). Be sure to select the channel at the
Cable Box and leave the Cable Box on for the timer recording.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL – –
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
6
Press two Number buttons for the hour(s) you want the
recording to begin. Press two Number buttons for the
minute(s) you want the recording to begin. Press 1 for
AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON – – : – –
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
7
Follow the instructions in step 6 to set the recording's
stop time. (AM or PM will be set automatically.)
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON 09:30 PM
TIME OFF – – : – –
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
Timer Recording (cont'd) 33
4-7
2
1
5
4
8
7
0
–
REW
Helpful Hints
• If the numbers entered do not
match the TV/VCR's internal calen-
dar, the entry will be rejected and a
question mark (?) will appear on
the TV/VCR screen.
• To make corrections while you are
programming a timer recording,
press the CLEAR button until the
cursor is flashing on the item you
want to change. Then enter the cor-
rect information.
3
6
o
9
p
+100
o
p
o
PLAY
+
F.FWD
STOP
p