Table of Contents
Advertisement
Source Unit
(VCR or Camcorder)
VIDEO
AUDIO
OUT
IN
From AUDIO OUT to AUDIO
AUDIO and
VIDEO OUT
Jacks
From VIDEO OUT to VIDEO
1
Make the connections shown above, using audio and video
cables.
2
The source unit (VCR or camcorder) will play your tape. Insert a
prerecorded tape in the source unit. If playback begins, press
the STOP button on the unit.
3
The TV/VCR will record your tape. Insert a blank tape in the
TV/VCR. Make sure the tape's record tab is intact. The TV/VCR
will turn on automatically.
4
Point the remote control at the TV/VCR. Press Number
buttons 0, 0 so that A/V IN appears on-screen.
5
Point the remote control at the TV/VCR. Press the
(Tape) SPEED button until the desired tape speed (SP,
LP, or SLP) appears on-screen.
6
Press the PLAY button on the source unit and the
REC(ord)/OTR button on your TV/VCR at the same time.
Copying will begin.
7
To stop copying, press the STOP/EJECT button on the
TV/VCR, then stop the tape on the source unit (VCR or
camcorder).
Rerecording (Tape Duplication) 31
POWER
STOP
AUDIO
VIDEO
REC
EJECT
AUDIO and
VIDEO Jacks
on TV/VCR
• Unauthorized recording of copy-
righted television programs, video
tapes, or other materials may
infringe on the rights of copyright
owners and violate copyright laws.
• Different brands of equipment may
operate differently.
• Make sure all connections are
secure. Otherwise, you may not
record both picture and sound.
• Audio and video cables are not
included.
Helpful Hints
Advertisement
Table of Contents
