Care And Cleaning; Lamp Replacement; Oven Lamp - Hotpoint RJ742GJ Use And Care Manual

Care and Cleaning

(See Cleaning Guide on page 24.)
Proper care and cleaning
procedures are essential for a
long and satisfactory life for your
oven(s). When cleaning an oven
manually, wearing of rubber gloves
is recommended to protect the hands.
The porcelain enamel finish is
essentially glass fused on steel at
high temperature and is breakable
if misused. This finish is acid-
resistant. However, any acid foods
spilled (such as lemon or other
citrus fruit juices, or mixtures
containing tomato or vinegar)
should be wiped up immediately.
See guide for cleaning suggestions.

Lamp Replacement

CAUTION: BEFORE
REPLACING ANY LAMP,
DISCONNECT ELE~RIC
POWER ~ OVEN AT THE
MAIN FUSE OR CIRCUIT
BREAKER PANEL. LET LAMP
(OR BULB) AND LAMP COVER
COOL COMPLETELY.
After replacing lamp (bulb),
reconnect electrical power to the
range.

Oven Lamp

If the oven lamp (bulb) has a
removable glass cover which is
held in place with a bail-shaped
wire...
Hold hand under cover so it
doesn't fall when released. With
fingers of same hand, firmly push
down wire bail until it clears cover.
Lift off cover, DO NOT
REMOVE
ANY SCREWS TO REMOVE
THIS TYPE OF COVER.
Replace bulb with a 40-watt
home appliance bulb.
To replace cover:
Place cover into groove of lamp
receptacle. Lift wire bail up to
center of cover until it snaps into
place. When in place, wire holds
cover firmly, but be certain wire
bail is not below depression in
center of cover.
22
If lamp cover is held in place with
three slotted screws . . .
. Remove the screws, remove cover,
and replace bulb with 40-watt
appliance bulb.
Replace lamp cover with three
screws.