Table of Contents
Advertisement
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.
4.
Select ADVANCED > Setup > LAN Setup.
5.
In the IP Address field, type the IP address.
6.
In the IP Subnet Mask, type the subnet mask of the router.
The IP address and subnet mask identify which addresses are local to a specific device
and which must be reached through a gateway or router.
7.
Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information with
other routers.
a. In the RIP Direction list, select one of the following:
•
Both. The router broadcasts its routing table periodically and incorporates
information that it receives.
•
Out Only. The router broadcasts its routing table periodically.
•
In Only. The router incorporates the RIP information that it receives.
b. In the RIP Version list, select one of the following:
•
Disabled. This is the default setting.
•
RIP-1. This format is universally supported. It is adequate for most networks,
unless you have an unusual network setup.
•
RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the
routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses
multicasting.
8.
Click the Apply button.
Your changes are saved.
Nighthawk X6 AC3200 Tri-Band WiFi Router
Network Settings
116
Advertisement
Table of Contents
