Compass; Clock - GMC 2016 Sierra Denali Owner's Manual

Compass

The vehicle may have a compass
display on the Driver Information
Center (DIC). The compass receives
its heading and other information
from the Global Positioning
System (GPS) antenna,
®
StabiliTrak , and vehicle speed
information.
The compass system is designed to
operate for a certain number of
miles or degrees of turn before
needing a signal from the GPS
satellites. When the compass
display shows CAL, drive the
vehicle for a short distance in an
open area where it can receive a
GPS signal. The compass system
will automatically determine when a
GPS signal is restored and provide
a heading again. See Compass
Messages 0 127 for the messages
that may be displayed for the
compass.

Clock

Setting the Time and Date with
Faceplate Controls
To set the time or date:
1. Select SETTINGS from the
Home Page, then select Time
and Date.
2. Select the desired function.
3. Turn the MENU knob to
increase or decrease the value.
4. Press the MENU knob to go to
the next value. After the last
value is selected, the system
will update and return to the
Settings menu. Press
to go to the last menu and
save the changes.
Auto Set requires an active
connection to OnStar.
If auto timing is set, the time
displayed on the clock may not
update immediately when driving
into a new time zone.
Instruments and Controls
To set the clock display:
1. Select SETTINGS from the
Home Page, then select Time
and Date.
2. Select Clock Display.
3. Turn the MENU knob to Off
or On.
4. Press the MENU knob to
select.
Press BACK to go to the last
menu and save the changes.
Setting the Time and Date with
Touchscreen Controls
To set the time:
BACK
1. Touch SETTINGS on the Home
Page, then touch Time
and Date.
2. Touch Set Time, then touch
or to increase or decrease
hours, minutes, and AM or PM.
Touch 12 24 Hr for 12 or
24 hour clock.
3. Touch
previous menu.
101
to go back to the