Stihl MS 150 TC Instruction Manual page 24

English
Mounting the guide bar
1
2
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot.
3
4
Fit the guide bar over the stud (3)
N
and engage the peg of the tensioner
slide in the hole (4).
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
22
1
Fit chain around the sprocket (1)
N
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
2
Turn the tensioning screw (2)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
Refit the chain sprocket cover –
N
the pivot pin on the hand guard must
engage the guard on the engine
housing – and then screw the nut
onto the stud fingertight.
Go to chapter on "Tensioning the
N
Saw Chain"
MS 150 TC