Back Panel Fuse Location - Crown K Series Reference Manual

WARNING:
FUSE
OR ELECTRIC SHOCK, DO NOT EXPOSE
20 A @ 100-120 VAC
THIS EQUIPMENT TO RAIN OR MOISTURE.
10 A @ 200-240 VAC
Fig. 3.3 Back Panel Fuse Location
Page 24
TO REDUCE THE RISK OF FIRE
by bridging the outputs, and it requires special loudspeaker
wiring. Do not use the black binding post outputs when the Do not use the black binding post outputs when the Do not use the black binding post outputs when the Do not use the black binding post outputs when the
Do not use the black binding post outputs when the
Bridge Output switch is tur Bridge Output switch is tur
Bridge Output switch is turned on. Bridge Output switch is tur Bridge Output switch is tur
the black binding posts may result in a visit by the Binding-
Post Police. (See Section 2 for more information.) When the
Bridge Output switch is turned on, only the Channel 1 level
control will work.
"Y" Input: This on/off switch combines the two amplifier input
channels by "Y-ing" or paralleling them together. When the "Y"
Input switch is turned on, a signal fed into either input channel
will be fed to both outputs and the individual level controls of
each channel will continue to work independently.
Fuses
A fuse is provided to protect the power supplies from excess
current. It is located on the back panel below the power cord.
A 20-amp fuse should be used for all K-Series amplifiers that
are configured to use 100-120 VAC power. A 10-amp fuse
should be used for all units configured to use 200-250 VAC
power.
To replace the fuse follow these steps:
1. Turn down the level controls of the amplifier.
2. Turn off the amplifier and disconnect it from the AC recep-
tacle.
3. Remove the fuse by rotating the cap of the fuse holder
counter-clockwise with a flat-blade screwdriver.
4. Replace the fuse only with the specified type listed above
K-Series Balanced Current Amplifier™
OUTPUTS
CH-2 CH-1
ned on. ned on.
ned on. ned on. Connecting anything to
OUTPUT WIRING
STEREO BRIDGE-MONO