Fisher & Paykel ActiveSmart RS90A Installation Instructions Manual page 16

1
Carefully open the French doors and remove hinge end caps.
2
Left hinge end cap
Hold onto the corner of the end cap,
firmly push to the right to disengage
securing hook and pull down.
3
Pull cap gently towards the left hinge
to remove.
Reserve end hinge cap
for later installation
It is important that all four corners of the product is supported firmly
● ●
onto the floor to eliminate any movement.
Installing the appliance on a soft or uneven/unlevelled floor may result
● ●
in twisting of the product and poor door sealing.
Raise the product using an 11 mm hex socket or 4 mm hex Allen key.
● ●
One turn of height adjusting nuts is equivalent to 1 mm height travel.
Note: maximum torque travel 20 mm.
1
Raise the front of the product until the
fixing brackets contact the ceiling of
the enclosure (refer to B).
Turn clockwise to raise roller or
counter-clockwise to lower roller.
repeat on opposite side.
14
!3 rEmovING HINGE ENd CAPS
!4 lEvEllING yoUr APPlIANCE
4
Right hinge end cap
Press on the centre of the end cap
and push towards the right hinge
to remove.
Reserve end hinge cap
for later installation.
B
2
Raise the rear of the product until
the refrigerator doors are flush with
the front face of adjacent walls.
Turn clockwise to raise roller or
counter-clockwise to lower roller.
repeat on the opposite side.
Gently push the front of the product
to check the stability and to ensure
side gaps are even with enclosure.