Installation - IOGear GKM561R Quick Start Manual

Installation

STEP 1
Connect the USB RF
receiver into any open
USB port of your
computer while the
computer is turned on.
STEP 2
Open the battery cover on the back of
the keyboard and insert the 2 included
AA batteries into the battery
tray.* Then, close the battery
tray by putting the battery
cover back on.
*Note: Please make sure the batteries are
installed properly as the directions that
are indicated inside the battery tray
STEP 3
Turn on the keyboard by switching
the ON/OFF switch to the
ON position.
FINAL STEP
Now the keyboard and trackball should be working properly.
If the keyboard and trackball are not working, please see the
Pairing Section.
RESET
ON/OFF
3
RESET
ON/OFF