Hardware Installation; Operation - IOGear GKB632B Quick Start Manual

Hardware Installation

Installing the batteries:
1. Open the battery cover on the back of the keyboard.
2. Insert two AAA batteries. Make sure the batteries are installed in the orientation
shown inside the battery tray.
3. Close the battery tray.
Using the folding stand:
The folding stand is designed with 3 viewing angles to support your
smartphone/tablet in portrait or landscape mode. The following
diagram shows how to deploy the stand:

Operation

Pairing GKB632B with a Bluetooth enabled device:
Single pairing:
1. Turn on the Bluetooth function on your device.
2. Slide the GKB632B power switch to the ON position.
3. Press fn +1 together on the Bluetooth keyboard and then release both keys.
4. Press the "Connect" button on the back of the keyboard to activate Bluetooth
pairing mode.
a. The white LED will flash slowly.
5. Open the Bluetooth settings on the your device
6. Search/Scan for new devices. Select "IOGEAR GKB632B Keyboard" from the list of
the available devices.
7. The device will show connected after the GKB632B has been successfully paired.
Multi-pairing:
1. To pair another Bluetooth device to GKB632B, follow the steps under
Single pairing and substitute fn + 2 for the second device, fn + 3 for the
third, or fn + 4 for the fourth device you wish to connect.
Switching to the desired device:
1. Make sure to turn on Bluetooth for the desired device.
2. Press fn + the key for the device number (keys 1-4), then release both keys.
3. Press fn + Tab to switch back and forth between the two most recently
connected devices.
Factory Reset:
1. Slide the GKB632B Power Switch to the ON position.
2. Press fn + "Connect Button" together.
a. White LED will flash once.
3