Conditional Access Module (Ca Module); Web Key Function - Loewe Reference 55 User Manual

Reference 55
User guide
Functions

Conditional Access module (CA module)

In order to receive coded digital stations, a Conditional Access module
(CA module) and a Smart Card must be inserted in the CI slot of your
TV set.
The CA module and the Smart Card are not part of the set of
equipment supplied with the TV set. They are usually available from
your dealer. Loewe does not provide any guarantee for the functioning
of the CA module.
The TV set must first recognise and set up the CA module during initial
operation. Therefore, it can take up to a minute until decoding starts
during initial operation.
Inserting the Smart Card into the CA module
Push the The side of the card with the gold chip on it should be pointing
towards the thicker side of the insertion slot (see illustration). Note
the direction of the arrow printed on the Smart Card.
CA module
Inserting the CA module into the TV set's CI slot
Switch off TV set using the mains switch.
Remove the cover from the rear of the set.
Insert the CA module carefully into one of the two CI slots, ensuring
that the contact side goes in first. Do not use force. Make sure the
module is not twisted in the process. Push the CA module in as far as
it will go.
Finally, close the side cover.
Calling CA module information
This menu is only available when a CA module is
plugged in.
HOME: Call Home view.
Select System settings,
OK call System settings.
Select Extras,
go to next column.
Select desired CA module.
The indicated name depends on the inserted
CA module.
go to next column.
Select Module menu,
OK call.
The content of this menu depends on the provider of
the CA module.
.
Searching for scrambled stations
If no search for encrypted stations was performed during initial startup,
this can be done later using the search wizard.
Smart Card
Removing the CA module
Remove the cover from the rear of the set.
Pull the CA module out of the CI slot.
Replace the cover.

WEB key function

You can assign the Web key on the remote control unit a particular
function (MediaNet, picture/sound menu, sound mode, etc.).
The selected function will then be called directly when the key is
pressed.
Call WEB key settings
HOME: Call Home view.
Select System settings,
OK call System settings.
Select Stations,
go to next column.
Automatic scan TV+Radio,
go to next column.
Select Change search settings,
OK wizard guides you through the search settings.
Under scrambled stations you have to select yes.
Next select Start search/update,
OK start updating the station list.
Switch off TV set using the mains switch.
Default setting: MediaNet
HOME: Call Home view.
Select System settings,
OK call System settings.
Select Control,
go to next column.
Select more ...,
call other settings.
Select key function,
go to next column.
... key
WEB
function
Sound/pic-
ture music
Sound
mode
Picture for-
mat
Headphone
volume
3D
Internet ra-
dio
Photo
Video
Select function,
OK Adopt.
You can assign the button another function here.
Adopt with
WEB
The selected function is then accessed directly when the
button is pressed.
OK
45