Onboard Devices Configuration - Asus Z170M-E D3 User Manual

The USB Devices item shows the auto-detected values. If no USB device is detected, the
item shows None.
Legacy USB Support [Enabled]
[Enabled] Your system supports the USB devices in legacy operating systems.
[Disabled] Your USB devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
[Auto] Your system automatically detects the presence of USB devices at startup.
If any USB devices are detected, the legacy USB support is enabled.
XHCI Hand-off [Disabled]
[Enabled] Enables the support for operating systems without an XHCI hand-off
feature.
[Disabled] Disables the XHCI Hand-off support.
USB Single Port Control
The subitems in this menu allow you to set the USB Port Disable Override features.
USB3_1/2/3/4/5/6/7/8, USB9/10/11/12/13/14 USB Port [Enabled]
Allows you to enable or disable the USB ports individually. Configuration options:
[Disabled] [Enabled]
Refer to section 1.2.3 Motherboard layout for the location of the USB ports.
2.6.7

Onboard Devices Configuration

HD Audio Controller [Enabled]
[Enabled] Enables the HD Audio Device.
[Disabled] Disables the HD Audio Device.
The following two items appear only when you set the HD Audio Controller item to
[Enabled].
Front Panel Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC'97 or
high-definition audio depending on the audio standard that the front panel audio
module supports.
[HD Audio]
[AC97]
SPDIF Out Type [SPDIF]
[SPDIF]
[HDMI]
ASUS Z170M-E D3
Sets the front panel audio connector (AAFP) mode to high definition
audio.
Sets the front panel audio connector (AAFP) mode to legacy AC'97
Sets to an SPDIF audio output.
Sets to an HDMI audio output.
2-33