Setting The Clock; Auto Clock Setting - Magnavox H2160MW9 A Owner's Manual

Set the clock before you try the timer programming. If a PBS (public broadcasting station) is available in your area,
follow "Auto Clock Setting" below. If not, follow "Manual Clock Setting" on page 33.

Auto Clock Setting

This unit can set the time and date automatically by
referring to a PBS station.
Make sure
• The antenna/cable TV connections are correct.
• Channels are set. (Refer to page 29.)
• If this unit is connected to a cable/satellite box,
select the local PBS station on them to set the clock
automatically.
STANDBY-ON STANDBY-ON DTV/TV
.@/: .@/:
GHI GHI
PQRS PQRS
SETUP SETUP
DISC MENU
DISPLAY
V.REPLAY
RAPID PLAY
D.DUBBING
TIMER
Note
• The clock may set itself automatically after you
connect the antenna/cable signal and plug in the
power cord.
• Only the analog PBS channel signal is effective for
auto clock setting.
• The unit receives the clock data at 12:00 a.m. / p.m.
from the PBS channel when the power is in the
standby mode.
32 32 EN EN

SETTING THE CLOCK

OPEN/
SOURCE CLOSE
ABC ABC DEF DEF
CHANNEL
JKL JKL MNO MNO
TUV TUV WXYZ WXYZ
SPACE SPACE CLEAR
AUDIO REPEAT HDMI
TITLE
OK OK
RETURN
V.SKIP
HDD DVD
REC MODE REC
1
Press [SETUP] and use [K / L] to
select "General Setting", then press
[OK].
"General Setting" menu will appear.
2
Use [K / L] to select "Clock", then
press [OK].
"Clock" menu will appear.
3
Use [K / L] to select "Auto Clock
Setting", then press [OK].
4
Use [K / L] to select "Auto", then
press [OK].
Auto Clock Setting
OFF
Auto
Manual
5
Press [SETUP] to exit.
6
Press [STANDBY-ON y y ] to turn the
unit to the standby mode.
This unit will search for the time only when the
power is in the standby mode. Leave it in
standby for several minutes to give this unit time
to set the clock.
If the unit chooses an incorrect PBS channel, set the PBS
channel manually by following the steps below.
1
Select "Manual" at step 4, then press
[OK].
2
Use [the Number buttons] or [K / L]
to enter your PBS channel number,
then press [OK].
Set Channel No.
CH 1
3
Press [SETUP] and turn the unit to
the standby mode.