Attaching The Spindle Unit - Epson SL-D700 Operation Manual

SL-D700 Operation Guide
D
Insert the flange into the shaft of the spindle unit so that the core of the roll paper is held securely between the top
and bottom flanges.

Attaching the Spindle Unit

A
Adjust the inner edge guide of the roll paper feeder to the width of the paper.
To adjust the position of the inner edge guide, lift it towards you slightly and move it to the left or right. Match
the triangle mark on the inner edge guide to the scale. The scale is in millimeters (inches in parenthesis).
B
Hold the spindle unit in the direction shown below, and then place it in front of the roll paper feeder.
Remove any tape or protective sheets from the paper.
Replacing Paper
32