Mazda 6 Smart Start Manual page 35

SPEEDOMETER INFORMATION
TYPE B INSTRUMENT CLUSTER
WARNING LIGHTS ONLY.
These warnings are displayed as text in the
Type A Information display.
Automatic Transaxle Warning
Blind Spot Monitoring OFF
(BSM)
(p. 23)
KEY Warning
KEY Indicator
Door Ajar
Trunk Lid Ajar
Low Washer Fluid Level
Warning
Check Fuel Cap
Perform Maintenance
SPORT Mode On
Lane Departure Warning
System (LDWS) ON (AMBER)
Lane Detected (GREEN)
Lane Departure Warning
System (LDWS) OFF
(AMBER)
3
Brake Pedal Operation
Demand
See page 7 or the
Owner's Manual for
further information.
FUEL
DISPLAY GAUGE
RED
GREEN
(p. 21)
3
www.MazdaUSA.com
TYPE B CLUSTER
INFORMATION
DASHBOARD ILLUMINATION/
DIMMER
ENGINE COOLANT TEMP LIGHTS
Since this vehicle does not use an
engine coolant temperature gauge, red
and blue engine coolant temperature
lights are used to indicate high
and low coolant temperature.
Red Coolant Temp Light
Flashing: Engine is starting
to run hot. Drive slowly to
reduce engine load.
On: Engine is overheating. Safely pull
over to the side of the road and turn
the engine off. Refer to the Owner's
Manual for more information.
Blue Coolant Temp Light
On: Engine coolant is cold
and no warm air is available
for heater/defroster.
Off: Engine coolant is warm and
warm air is available for heater/
defroster. The light may stay on for a
few minutes after start-up when the
engine is cold, but the vehicle can
be driven with the light on or off.
• Rotate the knob to adjust the brightness of the
1
instrument cluster and other dashboard illuminations.
• Push to toggle between trip meter (A & B).
2
• When a trip meter is selected, push and hold to
reset to zero.
• Indicator is also displayed in Type A Cluster
3
Information Display.
DISPLAY
/
TRIP METER
1 2
34