Canon 550ex Full Manual page 10

o---o
E
Wireless Flash Range
A C h e c k t h a t t h e m a s t e r u n i t ' s p i l o t
\' lamp is lit and that the slave unit(s)
are recharged and ready.
. W h e n a s l a v e u n i t i s r e a d y , i t s A F - a s s i s t
beam blinks once per second.
A P r e s s t h e m a s t e r u n i t ' s p i l o t l a m p
'i
(test firing button) to fire a iest flash.
. W h e n t h e w i r e l e s s t r a n s m i s s i o n w o r k s , t h e
slave units fire at 1/64 output in the following
slave lD order: A, B, and C.
. lf a slave unit does not fire, place it closer to
t h e m a s t e r u n i t o r a n g l e t h e s e n s o r m o r e
toward the master unit and try again.
ln a wireless flash system, the flash mode (E-TTL autoflash, high-speed sync, manual
flash, stroboscopic flash), flash exposure compensation, flash exposure bracketing,
and other settings are all set with the master unit. The master unit transmits all these
settings to the slave units by wireless signals. Controlling slave unit(s) is the same as
controlling one on-camera Speedlite.
With the EOS-3, a modeling flash can be fired to check the lighting effects (lighting
balance; shadows, etc.) before you take the picture. See page 50.
Make sure the slave units are within the effective range of the master unit.
After the picture is taken, the slave unit's operation result is displayed on the LCD
panel.
With the slave unit's main switchs€t to SE (Save Energy), the slave unit turns off
automatically if it is left unusedJt#bver 60 minutes*. While the slave unit is off due to
this SE mode, SE is displaied on the LCD panel. Within t hour"* after the slave unit
turns off in the SE mode, the Slave unit can be turned on again by pressing the master
unit's test firing button.
lf the manual flash mode has been set and you press the master unit's pilot lamp, all
the slave units will fire a test flash simultaneously
at the manually-set flash output.
After pressing the shutter button halfway, test firing cannot be executed during the first
6 sec.
!f|
. Custom Function CF-4 can change this to 10 minutes. See page 1 13.
** Custom Function CF-5 can change this to 8 hours. See page 1 13.
59