Magnavox VRX562AT99 Owner's Manual page 43

Timer Recording With the VCR Plus+ Programming System (cont'd) 43
5
Press the Number 1 button to record in SP speed, the
Number 2 button to record in LP speed, or the Number 3
button to record in SLP speed. Your selection will appear to
the right of REC SPEED on-screen, although SP=1 LP=2 SLP=3 will
continue to flash. For details about tape speed, see pages 36 and
60. You cannot use the (Tape) SPEED button at this time.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 09
TIME ON 10:30 PM
TIME OFF 11:30 PM
REC SPEED SLP
SP=1 LP=2 SLP=3
START DATE 10/10/97
FRI.
TO END PUSH EXIT
6
Press the STATUS/EXIT button. PROGRAM WAS COM-
PLETED / PLEASE TURN OFF VCR FOR TIMER RECORDING
should appear on the screen. After three seconds, the on-screen
display will disappear.
7
Press the POWER button to turn off the VCR power. The
Timer light will appear. The Timer light will flash if there is not a
tape in the VCR.
If the timer recording will take place several hours or days from
now, you may use the VCR until time for the recording. Just turn
off the VCR a few minutes before the recording starts.
The VCR must be turned off for a timer recording to take
place. If you forget to turn off the VCR, PLEASE TURN OFF
VCR FOR TIMER RECORDING flashes on your TV screen two
minutes before a timer recording starts. You can remove the mes-
sage by pressing the CLEAR button.
The VCR must be off for a
timer recording to take
place! Make sure there is a
tape in the VCR.
CBL/DSS VCR TV
7
POWER VCR PLUS+
PAUSE
/ENTER
/STILL
SLOW F.ADV
6
STATUS/EXIT CLEAR
MENU
V C
5 VOL CH
V C
1 2 3
4 5 6
7 8 9
100 0
A.CH
INDEX SKIP
REC/OTR SEARCH SEARCH VCR/TV
SPEED MEMORY
EJECT X2 PLAY VAR.SLOW TRACKING
MUTE TIME SEARCH REC END SEARCH
JOG & SHUTTLE
Helpful Hints
• To exit the VCR Plus+ programming
system at any time, press the STA-
TUS/EXIT button. The display will
disappear from the TV screen.
• If the preset time for a timer
recording comes up during an OTR,
the OTR has priority.
• To stop a started timer recording,
press the STOP/EJECT button on
the VCR.
• If the power fails for more than one
hour, programmed timer recordings
may be lost. Reset the clock before
re-programming the timer record-
ings.
• If you are using a Cable Box/DSS
Receiver, timer recordings are pro-
grammed differently. Details are on
page eight.
See page 58 for more hints.