Mounting An Optional Ev-200 Voice Announcement Board - Toa VM-2120 Installation Instructions Manual

15. MOUNTING AN OPTIONAL EV-200 VOICE ANNOUNCEMENT BOARD

Caution: Leave the following work to a qualified service technician.
Be sure to unplug the AC power cord before the work.
Do not handle unless your body is static-free because some of the assembled components are
sensitive to static electricity.
Step 1. Set the DIP switch on the EV-200 Board as shown in the figure.
DIP switch
ON
OFF
Always set to OFF.
(ON position is for factory test.)
EV-200 surveillance signal output on-off (Switch No. 2)
Be sure to set to ON. (A 1 kHz signal output)
EV-200 surveillance signal output (Switch No. 2)
The EV-200 board always transmits a 1 kHz sine wave signal to an amplifier when the EV-200 Board is not
reproducing audio signals. The amplifier detects the existence of the 1 kHz signal. When the signal does not
exist, the amplifier judges the board's failure and causes the FAULT indicator to light.* (The signal indicating
the EV-200's failure is transmitted from the CONTROL I/O connector.)
* If Switch No. 2 is set to the OFF position, the FAULT indicator lights even when the board is operating
correctly.
Step 2. Remove 4 screws on the amplifier rear panel and a total of 6 screws on the sides to remove the
cover.
Rear: M3 x 6 machine screw and M3 plain washer ..... 4 pieces
Step 3. Insert the EV-200 connection cable coming from the EV-200 Board into connector CN8 in the
amplifier.
CN6 CN8
Rear panel
DIP switch
Side: M4 x 8 machine screw ..... 3 pieces each
EV-200 connection cable
EV-200 Board
CF card connector
EV-200 Board
5