Installing The Radio - Magnadyne PPC-200 Owner's Manual

INSTALLING THE RADIO

1. Anchoring Board
2. Flat Washer
3. Machine Screw
4. Mounting Strap
5. Hex Nut
6. Shaft Nut
7. Dashboard
8. Trim Plate
Installing the Radio
1. Locate the factory supplied opening for the radio or choose a location within reach of
the primary operator of the vehicle.
2. Cut and file the opening if necessary so the shafts and the nosepiece of the radio will
slide through the opening.
3. Place the spacing nuts and washers on the shafts and adjust them so that the nosepiece
and shafts stick through the mounting far enough for the face plate to be positioned and
held into place using the remaining nuts and washers. If the face plate is not used,
adjust the radio depth so that the knobs will fit and operate smooth and correctly.
5
1
4
2
3
5
2
2
7
8
5
6
2
6
4. Support the rear of the chassis using the
perforated back strap and nuts supplied.
Attach the back strap to the rear chassis of
the radio and find a secure, solid location
to attach the end of the back strap.
Note: Reluctance to use or properly
install the back strap will result in
damage to the shafts and will cause the
nosepiece to become distorted.