Table of Contents
Advertisement
B
Regulatory compliance and safety
Laser device
All HP systems equipped with a laser device comply with safety standards, including International
Electrotechnical Commission (IEC) 825. With specific regard to the laser, the equipment complies
with laser product performance standards set by government agencies as a Class 1 laser product.
The product does not emit hazardous light.
Laser safety warning
WARNING!
•
Do not try to open the laser device enclosure. There are no user-serviceable components inside.
•
Do not operate controls, make adjustments, or perform procedures to the laser device other
than those specified herein.
•
Allow only HP-authorized service technicians to repair the laser device.
Certification and classification information
This product contains a laser internal to the fiber optic (FO) transceiver for connection to the Fibre
Channel communications port.
In the USA, the FO transceiver is certified as a Class 1 laser product conforming to the
requirements contained in the Department of Health and Human Services (DHHS) regulation 21
CFR, Subchapter J. A label on the plastic FO transceiver housing indicates the certification.
Outside the USA, the FO transceiver is certified as a Class 1 laser product conforming to the
requirements contained in IEC 825- 1 :1993 and EN 60825- 1 :1994, including Amendment
1 1:1996 and Amendment 2:2001.
Laser product label
The optional label in
device.
Figure 1
Class 1 laser product label
FC1142SR and FC1242SR DC 4Gb PCI Express host bus adapters for Linux and Windows installation guide
To reduce the risk of exposure to hazardous radiation:
Figure 1
or equivalent may be located on the surface of the HP-supplied laser
31
Advertisement
Table of Contents
Troubleshooting
