Specific Attachment For Comfort Version - Invacare Action 4NG series User Manual

4.3. Specific attachment for Comfort version only
(test report n° S10948) (available as a kit).
1- Install the lateral belts on top, see detail A:
- wrap the lateral belt around the backrest tube (small buckle
for 40 cm seat depth and large buckle for 45 cm) and cover
the shell attachment.
- the lateral belt must be placed on the shell fixation, see
detail A.
- firmly tighten the lateral belt.
2- Lock the lateral belt, see detail B:
- pass the small nylon loop on through the side support, pull
until the hook is in locked position.
Note: to release the lateral belt hook, pull on the small nylon
14
loop until you unlock it.
3- Fit the back brace on the backrest push handle (see
paragraph 2.6.1), remove the headrest and trunk support if
equipped.
4- Install the snap hooks on the rear tie down bracket, see
detail C
Your Comfort version is now ready to be transported in a
vehicle, see photo 25.
Please strictly follow the rules detailed in the paragraphs 4.1
Observations before transport of wheelchairs in vehicles and
4.2.Restraint systems in the previous pages.
!
This attachment is mandatory to be used for car trans-
portation, no other attachment is permitted !
See additional information (ref.1537507) joined with the Com-
fort attachment kit.