Magnadyne MV-VCRUSER02 Owner's Manual page 8

6. Stereo/Mono Switch:
If a condition of interference arises and it can not be reme-
died by selecting another frequency, changing the transmit
mode from "Stereo" to "Mono" usually will eliminate inter-
ference noise. The audio performance will be reduced when
the switch is placed in the "MO" position. Return the
"ST/MO" switch to the "ST" position to re-gain the high
performance stereo sound in the headphones or the
Vehicles stereo system.
Stereo/Mono Switch
7. Transmitter Frequency Selection:
The Movievision TM viewing screen transmits a signal that
is received by the Movievision
be received by the vehicle's car radio. There are 3 fre-
quencies available for use but only one can be used at a
time. When you are listening to a movie using the wireless
Movievision TM headphones, it is possible that you could
travel through an area where interference between the
screen transmitter and the headphone receiver is at an un-
acceptable level. If this occurs, you can use the 3 position
frequency switch located in the roof housing to select a
different frequency that may have less or no interference.
Each time you change the transmitting frequency, the
headphone/car radio receiver will have to be re-tuned to
the new frequency. The 3 frequencies available for use are
89.7mhz, 90.1mhz or 90.5mhz. (For further information
on headphone tuning, consult the "Headphone Operation"
section of this manual)
Transmitter Frequency Selection Switch
8
6.4" Viewing Screen Controls and Functions
TM headphones and can also
Car Radio Interface:
The signal transmitted from the Movievision
received by the existing
listening mode provides a much higher quality of sound for
all. To listen to the Movievision
stereo system, repeat the following procedures;
A. Turn "ON" the Movievision
attach an auxiliary signal source to view on the screen.
B. Turn "ON" the FM radio in your vehicle and tune the radio
to one of the 3 frequencies transmitted by the
Movievision TM system. (89.7mhz - 90.1mhz - 90.5mhz)
C. Adjust the volume and tonal qualities to suit your listen-
ing taste.
TM screen can be
FM car radio. This
TM signal through the vehicle
TM system and insert a tape or