Magnadyne MV-VCRUSER02 Owner's Manual page 10

7. Transmitter Frequency Selection:
The Movievision TM viewing screen transmits a signal that
is received by the Movievision
be received by the vehicle's car radio. There are 3 fre-
quencies available for use but only one can be used at a
time. When you are listening to a movie using the wireless
Movievision TM headphones, it is possible that you could
travel through an area where interference between the
screen transmitter and the headphone receiver is at an un-
acceptable level. If this occurs, you can use the 3 position
frequency switch located in the roof housing to select a
different frequency that may have less or no interference.
Each time you change the transmitting frequency, the
headphone/car radio receiver will have to be re-tuned to
the new frequency. The 3 frequencies available for use are
89.7mhz, 90.1mhz or 90.5mhz. (For further information
on headphone tuning, consult the "Headphone Operation"
section of this manual)
Backlight Adjustment:
Adjusts the intensity of the rear panel lighting. For best results, this should be not be adjusted from the factory setting (50%
setting).
MENU SEL.
Press the Menu Button
Once
MENU SEL.
Press the Menu Button
Twice to Return.
10
10.4" Viewing Screen Controls and Functions
TM headphones and can also
Step 1
Screen Display
Step 3
Screen Display
Transmitter Frequency Selection Switch
Step 2
U SEL.
Press the Up and Down
Buttons to Adjust the
Backlight
BLT
Screen Display