Panasonic PT-JW130FWU Operating Instructions Manual page 42

1) Press asqw on the remote control to adjust the focus.
2) Press the <MENU> button on the remote control to perform rest of the initial setting.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press as on the remote control to select the display language.
2) Press the <ENTER> button on the remote control to perform next initial setting.
Initial setting (installation setting)
Set [PROJECTION METHOD] and [VERTICAL FLIP] depending on the installation conditions. Refer to
"Installation form" (x page 30) for details.
Set [HIGH ALTITUDE MODE] to [HIGH1] when using the projector at altitude between 1 000 m (3 281') and
2 000 m (6 562') above sea level, and set [HIGH ALTITUDE MODE] to [HIGH2] when using the projector at
altitude between 2 000 m (6 562') and 2 700 m (8 858').
Once the initial setting is completed, the settings for each item can be changed from the [SETUP] menu.
1) Press as on the remote control to select an item.
2) Press qw on the remote control to switch the setting.
3) Press the <ENTER> button on the remote control to perform next initial setting.
42 - ENGLISH
Chapter 3 Basic Operations — Turning on/off the projector
LENS
FOCUS
ADJUST
INITIAL SETTING
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
PORTUGUÊS
NEDERLANDS
SVENSKA
SUOMI
NORSK
Please select DISPLAY LANGUAGE.
SELECT
SET
ENTER
INITIAL SETTING
PROJECTION METHOD
VERTICAL FLIP
Change PROJECTION METHOD or VERTICAL FLIP if the
screen display is upside down or inverted.
HIGH ALTITUDE MODE
SWITCH TO HIGH ALTITUDE MODE "HIGH1" IF BETWEEN
1000m~2000m(3281Ft~6562Ft). SWITCH TO HIGH
ALTITUDE MODE "HIGH2" IF BETWEEN
2000m~2700m(6562Ft~8858Ft).
MENU SELECT
SET
ENTER
1/4
2/4
< FRONT >
OFF
OFF
CHANGE