Display Fault/Error Codes - LG DLEX5101W Service Manual

PROBLEM
Cannot see steam
vapor at the
beginning of cycle.
The display shows
BULKY LOAD.
Odors remain in
clothing after
STEAM FRESH™.
8-3. Display Fault/Error Codes for Steam Dryer
The error codes below will be displayed when attempting to start a drying cycle, or after
activating the Diagnostic Test mode.
Checking Part
DISPLAY
Thermistor of blower
tE1
housing
tE2
Door SW
dE
Wire Connection
PS
(Black-White-Red)
Thermistor of steam
tE4
generator
Add Steam generator
Water
E5
Water supply pump
EE
EE PROM Error
POSSIBLE CAUSES
• This is normal.
• MORE TIME button
pressed.
• STEAM FRESH™ did
not remove odor
completely.
• Thermistor open or shorted
• Door SW is abnormal. (Only
TEST MODE )
Wire Connection is wrong.
Wire Connection is loose.
• Steam generator thermistor
open or shorted.
• Sensors do not detect that
steam generator is full within 60
seconds.
• When the pump valve is less than
10 in the test mode
• EE PROM operation is abnormal. • EE error is only displayed in the
• Steam is released at different stages of the cycle
for each option.
• Pressing the MORE TIME button several times will
set the cycle for a large load such as a comforter.
• Fabrics containing strong odors should be washed in
a normal cycle.
Cause
18
SOLUTIONS
Remark
• tE1 error is displayed in the drying
cycle or test mode.
• Replace the steam generator.
• dE error is only displayed in the
test mode.
See the 7-9 page.
Guidance of the wire connection.
For only electric dryer.
*PS : Power Supply
• tE4 error is only displayed in the
test mode.
• Replace the steam generator.
If water in the steam feeder is not
enough this error may be isplayed.
Fill the feeder and restart the cycle.
• E5 error is only displayed in the
test mode.
• Check the connection between
harness wire and connector.
• Replace the water supply pump.
test mode.