TP-Link TD-W8901N User Manual page 54


Note:
The default PIN code of the modem router can be found in its label or the WPS configuration
screen as Figure 4-27.
• SSID: Wireless network name shared among all points in a wireless network. The SSID
must be identical for all devices in the wireless network. It is case-sensitive and must not
exceed 32 characters (use any of the characters on the keyboard). Make sure this setting
is the same for all stations in your wireless network. Type the desired SSID in the space
provided.
• Authentication Type: Select an authentication type from the drop-down list, which
allows you to configure security features of the wireless LAN interface. Options available
are: Disabled, WEP-64Bits, WEP-128Bits, WPA-PSK, WPA2-PSK, and WPA-PSK/
WPA2-PSK.
WDS Settings: Select On/Off to enable/disable WDS. With this function enabled, the modem

router can bridge two or more WLANs.
• MAC Address: Enter the MAC Address you wish to bridge in the field.
Wireless MAC Address Filter: Wireless access can be filtered by using the MAC addresses

of the wireless devices transmitting within your network's RADIUS.
• Active: If you wish to filter users by MAC Address, select "Activated", and "Deactived" for
don't.
• Action: To filter wireless users by MAC Address, select "Allow Association" or "Deny
TD-W8901N 150Mbps Wireless N ADSL2+ Modem Router User Guide
The WPS Configuration Screen of Wireless Adapter
46