Canon MG3600 series Online Manual page 502

To check the access point name (SSID) and the password, print out the network setting information
of the machine.
Printing Network Settings
1. Turn on wireless communication on your device.
Enable "Wi-Fi" on your device's "Setting" menu.
For more on turning on wireless communication, see your device's instruction manual.
2. Select "XXXXXX-MG3600 series" ("XXXXXX" represents last six digits of machine's MAC
address.) from list displayed on device.
3. Enter password.
Your device is connected to the machine.
4. Start printing or scanning from your device.
Note
• For more on printing or scanning from a device via wireless LAN, refer to the device's or
application's instruction manual.
Terminating Access Point Mode
In environments that the machine is usually connected with the computer over the wireless LAN, set the
machine to the wireless LAN connection following the procedure below when you finish using the machine
with the access point mode temporarily.
1. Press and hold Wi-Fi button and release it when ON lamp flashes.
2. Press Color button, Black button, and then Wi-Fi button in this order.
The ON lamp changed from flashing to lit, the Wi-Fi lamp lights up, and then the wireless LAN is
enabled.
Note
• If you do not use the machine with the access point mode or over the wireless LAN:
Follow the procedure below to disable the access point mode and the wireless LAN.
1. Press and hold Wi-Fi button and release it when ON lamp flashes.
2. Press Black button twice and press Wi-Fi button.
The ON lamp changed from flashing to lit, the Wi-Fi lamp goes off, and then the wireless
LAN is disabled.
Access Point Mode Setting
The initial value of the access point mode is set as follows.
SSID (access point name) XXXXXX-MG3600series
502