Cateye Strada Smart CC-RD500B Online Manual page 122

If a connection cannot be established even when set to [ON], perform pairing with the
smart computer again. Solutions will vary depending on the smartphone and model.
• Padrone Smart users with iPhones
Remove the smart computer registered under [Settings] > [Bluetooth] on the iPhone.
Then remove the smart computer once under
Cycling™, and perform pairing again.
Smartphone : Pairing with smart computer
• For Strada Smart users and Android smartphone users:
Under (MENU) > [Device] in Cateye Cycling™, remove the smart computer once
and perform pairing again.
Smartphone : Pairing with smart computer
The display says "ready", but measurement will not start. What should I do?
Press MODE for 1 second. Smart computer displays Tm,
and you will be able to start measurement.
Tapping the (Start Measurement) in Cateye Cycling™
has the same effect.
Display alternates between PAUSE and Trip Distance, and measurement does not start.
Measurement is paused.
Press MODE for 1 second to resume measurement.
When using a speed (cadence) sensor (ISC-12), if the wheel magnet moves so that it is
not facing the sensor zone, the computer registers the speed signal as 0 and
measurement is not possible. (This is because the speed signal from the sensor has
priority over GPS when measuring speed.)
Have you paired the sensor?
• You must pair smart computer with your smartphone via Cateye Cycling™.
Smartphone : Pairing with a sensor
Are you using a Bluetooth Smart sensor?
• Smart computer can only receive signals from Bluetooth Smart sensors.
What is the problem?
Why can't I measure speed?
Why is the sensor signal not being received?
(MENU) > [Device] in Cateye
Measurement
standby
Trip distance
Paused
Alternate
display