Table of Contents
Advertisement
Sound Volume
■ To adjust the volume
● Press VOL (+) to increase the sound volume.
The numerical value increases.
VOLUME
50
● Press VOL (–) to decrease the sound volume.
The numerical value decreases.
VOLUME
10
■ To mute the sound
● Press e
e
e
e (Mute) to temporarily turn off the sound. The
e
MUTE mark is displayed on the screen.
● Press e
e
e
e (Mute) or VOL (+)/(–) to turn the sound back to
e
the previous level. MUTE is automatically cleared when one
of the following buttons is pressed: POWER,
e
e (Mute).
e
VOL (+)/(–) or e
e
VOLUME
10
Basic Operation (Continued)
Changing Channels
You can select channels using Channel Select or CH (
• To handle the increasing number of channels available, this
LCD TV set allows you to select up to 100 positions (Channels
0 to 99). One-digit and two-digit methods of selection can be
used. Follow the procedure shown below to select channels.
■ Using Channel Select
To select a one-digit channel (e.g., Channel 5):
1
Press 5 of Channel Select.
2
If "5–" is indicated and the picture does not change,
press -/-- to switch over to the 1-digit select mode and
press 5 of Channel Select.
To select a two-digit channel (e.g., Channel 15):
1
Press -/-- to set the 2-digit select mode.
2
Press 1 of Channel Select.
3
Press 5 of Channel Select.
NOTE
• Complete this procedure within 4 seconds, otherwise the selection
will not be made.
Changing channels with CH (
control.
Press CH (
) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .
Press CH (
) and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .
■ Using A
A
A
A (Flashback)
A
● Press A
A
A
A to switch the currently tuned channel to the
A
previously tuned channel.
● Press A
A
A
A
A again to switch back to the currently tuned
channel.
)/(
).
5
PAL
B/G
--
1-
15
PAL
B/G
)/(
) on the remote
9
Advertisement
Chapters
Table of Contents
