GMC Yukon XL 2015 Owner's Manual page 143

5-4 Instruments and Controls
z
If FRONT is then moved to
OFF before the driver door is
opened or within 10 minutes, the
wipers will restart and move to the
base of the windshield.
If the ignition is put in OFF while the
wipers are performing wipes due to
windshield washing or Rainsense,
the wipers continue to run until they
reach the base of the windshield.
Rainsense
With Rainsense, a sensor near the
top center of the windshield detects
the amount of water on the
windshield and controls the
frequency of the windshield wiper.
Keep this area of the windshield
clear of debris to allow for best
system performance.
INT (Rainsense Wipe
Sensitivity): Turn the
band on the wiper lever to adjust the
sensitivity.
Turn the band up for more
sensitivity to moisture.
Turn the band down for less
sensitivity to moisture.
Move the band out of the
position to deactivate Rainsense.
z
AUTO (Rainsense On/Off):
z
Press to turn Rainsense on or off.
FRONT
When turned on and
in one of the Rainsense wipe
sensitivity positions the wipers can
be adjusted for more or less
sensitivity to moisture. When turned
off, the wipers operate as timed
intermittent wipers and can be
adjusted for more or less frequent
wipes.
z
If
is turned on, or if the ignition is in
ON/RUN and the
is in one of the sensitivity settings
when
a message may display indicating if
INT
Rainsense was turned on or off.
If the ignition is in ON/RUN and
FRONT is not in one of the
sensitivity settings when
is turned on, a message may
display indicating that the wiper
band must be in one of the
sensitivity settings for Rainsense to
operate.
Wiper Arm Assembly Protection
z
FRONT is
When using an automatic car wash,
move the windshield wiper lever to
OFF. This disables the automatic
Rainsense windshield wipers.
AUTO is on when the ignition
z
FRONT band
z
AUTO is turned on or off,
z
AUTO
z