Washing Dishes - Bosch SGS 44E18 Instructions For Use Manual

Washing dishes

Reduce costs!
If only a small number of
dishes have been loaded into
the dishwasher, selecting a
programme that operates at
the next lowest temperature
will usually suffice.
Programme data
The programme data (duration, energy
and water consumption) can be found in
the summary of instructions and refers to
standard conditions. Greater deviations
may be caused by:
different quantities of utensils
inlet temperature of the water
water pressure
ambient temperature
mains voltage tolerances
and appliance-specific tolerances
(e.g. temperature, water flow rate, etc.)
The water consumption values refer
to water hardness value 2.
Switching on the appliance
Close the door.
Turn on the tap fully.
Rotate programme selector
required programme.
Switch on the main switch
The programme sequence display
lights up, the programme sequence starts
automatically.
Downloaded from DishWasher-Manual.com Manuals
End of programme
The programme ends when
the Programme progress indicator
6
the End-of-programme indicator
7
ends, the "Top basket washing" function
is de-activated if required (only some
models).
Several minutes after the programme has
ended:
Open the appliance door.
Wait until the dishes have cooled down
and then remove.
When the programme has ended, you can
either switch off the appliance or restart it
with the same or another programme.
Switching off the appliance
Several minutes after the end
of the programme:
Switch off the main switch
"End of programme" display
goes out.
Turn off the tap
(does not apply to Aqua Stop).
It is not necessary to adjust the
programme selector.
Remove the utensils when they have
cooled down.
Interrupting the programme
to the
3
Set the main switch
.
1
Indicator lights extinguish.
6
If the hot water was switched ON or the
appliance has already heated up and then
the appliance door opened, leave the door
ajar for several minutes and then close.
Otherwise, the appliance door may fly
open due to expansion.
In order to resume the programme, set
the main switch to ON again.
has gone out and
illuminates. When the programme
1
en
.
1
7
to OFF.
17